[TV] Re: (no subject)

["Mike Bates" <mbates17@xxxxxxxxxxxx>]

yes considering your vertical drive and output is on that board.

Check for out of tolerance resistors, or caps that have went high in ESR.
reason for this, sounds like either the drive or the voltages to the output
IC is insufficiant



----- Original Message -----
From: <cschoeberle@xxxxxxxxxxx>
To: <tv@xxxxxxxxxxxxxxx>
Sent: Monday, September 13, 2004 11:23 AM
Subject: (no subject)


> Has anyone fixed a Zenith Projection TV model PV4655LK with small vertical
sweep. The symptoms are:
> - Small picture about three inches short on top on bottom
> - The picture does not appear to be stretched (No fold over or retrace)
> - When you go into the service menu the vertical size option will increase
the picture to a certain point
> - The convergence is off in the lower corner of the screen
> Would the deflection module 9-629-02 be a good guess?
> Thank you in advance for your help,
> Craig
> --------------------------------------------------------------------------
----------
> TV email Archives at: http://www.circuitwork.com/archive/TV/
> To remove yourself: Email tv-request@xxxxxxxxxxxxxxx with remove as the
subject.
> Sent VIA Tech Assist's email server- tv@xxxxxxxxxxxxxxx
> --------------------------------------------------------------------------
----------
>
>


------------------------------------------------------------------------------------
TV email Archives at: http://www.circuitwork.com/archive/TV/
To remove yourself: Email tv-request@xxxxxxxxxxxxxxx with remove as the subject.
Sent VIA Tech Assist's email server- tv@xxxxxxxxxxxxxxx
------------------------------------------------------------------------------------