[TV] Re: Mitsubishi help VZ3 VS6047

["lynnslb" <lynnslb@xxxxxxxxxxxxx>]

This should help. Lynn
---------------------------------------------------------------
Text pasted from WinSTIPS 2.0
http://www.ServiceSoftware.com
---------------------------------------------------------------
MITSUBISHI   VZ3
Service Menu>
Option Menu "Menu 1370"
Service Menu "Menu 2357"
Convergence Menu "Menu 2359"
---------------------------------------------------------------
MITSUBISHI   VZ3
Similar To: Chassis To Model Cross>
Gregboyd1@xxxxxxxx
Ts-4545, Ts-5045, Ts-5545, Vs-4543, Vs-4544, Vs-5043, Vs-5044, Vs-5047,
Vs-6043, Vs-6047
---------------------------------------------------------------
MITSUBISHI   VZ3
Convergence    Red Alignment Shifts Intermittently
Jeff Stielau : 5/28/02 : Shoreline Electronics
Cracked Solder Connections On The Stk Outputs. Resolder All Mounted That Are
Mounted To The Heatsink.
---------------------------------------------------------------
MITSUBISHI   VZ3
Pcc And Convergence Distortion
Mela Tip
C936 In The -8v Line On Main Pcb.  16v 1000mfd
---------------------------------------------------------------
MITSUBISHI   VZ3
Pincushion Distortion - Top And Bottom Way Out Of Alignment : All 3 Rasters
Jeff Stielau : 4/8/04: Shoreline Electronics
Eprom Corrupted.
Checking The Geo Alignment Data ( Global Green Geometry) , All Values Were
Set For 127
Also , All The Red And Blue Data Values Were Set For 127 Also.
Starts By Realignning Green Raster For Proper Image Geometry , Then Do The
Red And Blue.
Time Consuming.......At Least An Hour Or So For Perfection!
---------------------------------------------------------------
 Techs;
does anyone have the EEPROM set up proceedure convergence and geometry for
 this set?  I do not have the manual and it got reset.  Mits wants
 $40...........worth it but we do not typically do these...............doing
 a favor for someone and it turned into one of the worst dogs I've ever had.

 I think there are more problems to the set, I have no syn on video but in
PIP its there.  Convergence way out, bowed top and bottom and when you have
 the convergence crosshatch up it "floats" around a bit.  Several components
 replaced to this point ............... any tips would be great.

 thanks
Randy

------------------------------------------------------------------------------------
TV email Archives at: http://www.circuitwork.com/archive/TV/
To remove yourself: Email tv-request@xxxxxxxxxxxxxxx with remove as the subject.
Sent VIA Tech Assist's email server- tv@xxxxxxxxxxxxxxx
------------------------------------------------------------------------------------